Meitrack T622G is a specially designed GPS tracker with the fleet management industry in mind. This unique tracker has the reliable specifications that all of Meitrack brand products hold plus more. Having an integrated battery, the T622G can bring up to 80 hours in power saving mode, and 9 hours in normal mode. It also comes equipped with a 3D acceleration sensor for use as a towing alarm or a vibration detection power switch.
Location and tracking
T622G model is embedded with GPS chip. As the back-up, when no satellites signals are available, it uses Cell ID location (also known as LBS-tracking).
The tracking mode is flexible and can be configured depending on distance, time and angle. The default parameters set by the system are 100m, 60 sec, 30 degrees. When there is no movement, tracker sends data every 180 seconds.
- 3 digital inputs (1 negative trigger, 1 positive trigger, and 1 positive/negative selectable trigger)
- 2 analog detection inputs
- 2 outputs
- 1 RS232 EXT port
- 1 RS232/485 port
- 1 USB port
- 1 CAN bus interface
- 1-Wire interface
With Quad-band GSM 3G module Meitrack T622G can be operated all over the world.
Meitrack T622G uses voltage range 11-36V, which makes possible to install it both on cars and trucks. Device also features a built-in rechargeable backup battery. When fully charged it ensures about 9 hours of device operation (in normal conditions).
Local and remote management
Meitrack devices support management via GPRS. Also, there is a wide list of SMS commands, on which device always replies back. In particular, Server address and port, APN settings can be applied remotely with SMS.
T622G has two status LEDs:
- Status LED: indicates GSM/GPRS mode
- Navigate LED: indicates GPS reception
|EU platform||tracker.navixy.com (126.96.36.199)|
|US platform||tracker.us.navixy.com (188.8.131.52)|
|Weight||190 g (6.7 oz.)|
|Size||105x65x26 mm (4.13x2.56x1.02 in)|
|Internal antenna (GNSS)||Yes|
|Cellular network type||GSM Quad Band|
|Internal antenna (Connection)||Yes|
|Cellular network generation||3G|
|Number of RS232 interfaces||1|
|Number of outputs||2|
|Number of inputs (all types)||5|
|Battery capacity||400 mAh|
|Fuel level sensor reading||Yes|
|Driver ID reading||Yes|
|External temperature sensor reading||Yes|
|Location by Cell ID||Yes|
|External power cut off||Yes|
|Network signal level||Yes|
|GNSS signal level||Yes|
|External power source voltage||Yes|
|Internal battery level||Yes|
|CAN/OBDII reader type||Yes|
|Server connection setup over SMS||Yes|
|Remote device configuration||Yes (over GPRS), Yes|
|Remote outputs control||Yes (over GPRS), Yes|
|Forced LBS location update over GPRS||Yes|
|Forced GNSS location update over SMS||Yes|