GoSafe Systems G79B is a portable vehicle GPS tracker that can be installed in OBDII port. This device designed for a fleet management and personal cars. It can read and transmit on-board PC data. The main feature of the device is the support of 2G and 3G networks. It also has a high-sensitive GPS receiver, built-in accelerometer and low power consumption system. The device is also equipped by device removal alert for securing the stability of its own work.
The G79B device is supplied to the customer in a cardboard box containing all the equipment that is necessary for operation.
The standard package contains:
- G79B device
- USB cable
- OBDII power supply adapter
Location and tracking
G79B model is embedded with GPS chip with the support of GLONASS technology as well. It also supports Assisted GPS (A-GPS) technology. As the back-up, when no satellites signals are available, it uses Cell ID location (also known as LBS-tracking).
The tracking mode is flexible configured: by moving every 100m, and every 60 sec, and on turning on 30 degrees by default. When there is no movement, tracker sends data every 180 seconds.
OBDII data reading
G79B supports reading of OBDII data from vehicle’s diagnostic system such as speed, engine RPM, coolant temperature, MIL, DTC codes, etc. It takes power supply from OBDII port and also can read board voltage.
G79B has a Quad-band GSM 2G module so it can be operated all over the world. Also it supports much faster and stable 3G connection
G79B uses OBD II Connector Type A and voltage range 10-16V, which makes possible to install it on cars. Device also features a built-in rechargeable backup battery. When fully charged it ensures about 1 hour of device operation (in normal conditions).
Local and remote management
GoSafe G79B tracker can be controlled over GPRS and it supports firmware updating via GPRS (FOTA). Also, there is a wide list of SMS commands, on which device always replies back. In particular, Server address and port, APN settings can be applied remotely with SMS.
You can also configure G79B from a PC using proprietary software and standard USB-cable which is included into package.
G79B has three LEDs:
- Green GSM LED: indicates GSM/GPRS mode
- Yellow GPS LED: indicates GPS reception
- Red Power LED: indicates power status
|EU platform||tracker.navixy.com (126.96.36.199)|
|US platform||tracker.us.navixy.com (188.8.131.52)|
|Special form factor||OBDII Dongle|
|Weight||80 g (2.82 oz.)|
|Size||52X57X28 mm (2.05x2.24x1.1 in)|
|Internal antenna (GNSS)||Yes|
|Cellular network type||GSM Quad Band|
|Internal antenna (Connection)||Yes|
|Cellular network generation||3G, 2G|
|Battery capacity||250 mAh|
|Location by Cell ID||Yes|
|External power cut off||Yes|
|Device switched on/off||Yes|
|Network signal level||Yes|
|GNSS signal level||Yes|
|GNSS satellites fixed||Yes|
|External power source voltage||Yes|
|Internal battery level||Yes|
|CAN/OBDII reader type||Yes|
|CAN/OBDII parameters||Fuel level, fuel consumption, engine RPM, throttle position, speed, engine load, coolant temperature, DTC error codes and other|
|DTC codes reading||Yes|
|Server connection setup over SMS||Yes|
|Remote device configuration||Yes (over GPRS), Yes|
|Firmware update OTA||Yes|