menu

TopFlyTech T8808A+

TopFlyTech model T8808A+ is a compact and affordable tracker for satellite monitoring of vehicles, motor bikes and other mobile objects. It has no external antennas, so the installation process is quite simple.

Mostrar más

T8808+ versions: “A” and “B”

In comparison to basic model T8808B+, which has no ouputs, the model T8808A+ features one output – for engine block relay or any other control device:

  • T8808A+ has 4 pin connector: Power, GND, ACC (orange) and Output (yellow)

Package content

The package contents:

  • GPS tracker
  • 4-pin harness (T8808A+ model)
  • Sponge double-side adhesive tape
  • Power supply extension line

Also as an option, manufacturer offers engine block relay for T8808A+ model.

Location and tracking

T8808A+ is embedded with GPS and it supports GLONASS and alternative systems. It also supports Assisted GPS technology. As the back-up, when no satellites signals are available, it uses Cell ID location (also known as LBS-tracking).

Mobile networks

With Quad-band GSM module T8808A+ can be operated all over the world.

Power supply

With a voltage range 6-36V, it is possible to install T8808+ both on cars and vans.

T8808+ also features a built-in rechargeable backup battery. When fully charged it ensures about 2-3 hours of device operation (in normal conditions). When external power is cut off, the tracker sends location to server.

To switch the tracker OFF you need to remove the SIM card, after that in 5-10 seconds the device will switch off.

Local and remote management

T8808+ tracker can be fully controlled over GPRS. There is also a wide list of SMS commands in a human-friendly format, on which device always replies back. It supports remote APN settings configuration by SMS.

LED Indication

T8808+ has two LEDs:

  • Red LED indicates GSM/GPRS mode
  • Blue LED indicates GPS reception

The LEDs light goes out automatically in five minutes after the device is switched on.

Additional notes

The “ACC” wire of T8808+ must be correctly connected. According to it, the device determines that vehicle is in use, switches GPS module to active mode and reports about its position to tracking server.

If there is no “ACC” signal, GPS module goes off and device does not send GPS coordinates. However, Cell ID information is updated regardless the “ACC” status.

There is also a “lifehack” which can be used for testing purposes or during the installation process: if you’re shaking the device within 60-70 seconds, GPS module will be enabled by accelerometer activity (regardless the “ACC” state) and device will update its location.


Conexión del servidor

Servidor de la UEtracker.navixy.com (52.57.1.136)
Servidor de USAtracker.us.navixy.com (13.52.37.2)
Puerto de servidor47744
Auto registro

Información general

FinalidadVehículo

Conectividad

Nivel de señal
ID del operador

Información de ubicación

Nivel de señal GNSS
LBS

Características

Control remoto de las salidas
Odómetro

Interfaces

Entradas digitales1
Número de salidas1
Active un dispositivo en la plataforma Probar
¿No ha encontrado su dispositivo? Podemos añadirlo Integrar
Video telemática ¡NUEVO!
Open
Video telemática ¡NUEVO!
Verifique incidentes
Determine responsabilidades
Entrene conductores
Leer más >
Open

Este sitio usa cookies.
Revise nuestra Política de Privacidad para saber más.

Do you want to switch to English version?

Yes No