ATrack AT1

Package contents

ATrack AT1 package contains the following device/accessories:

• ATrack AT1 device with battery backup
• Power/IO Cable for V6 power supply
• External active GPS antenna, SMA connector
• User manual
• Serial Cable

Additional contents

• CAN – RS232 – adapters with FMS firmware
• Garmin® FMI 2.0 devices
• Fuel flow sensors
• Capacitive fuel sensors
• RFID receiver
• Immobilizer
• Alarm button
• Wireless panic button
• Wireless lockout relay
• Digital sensors sensors such as “on / off”
• Temperature sensor
• Load sensor
• CAN – car alarm adapter

Product features:

• Small and easy installation
• Data communication by SMS/USSD/TCP/UDP
• High accuracy GPS positioning
• GSM jamming detection
• Built-in 3-axis G-sensor
• FOTA firmware upgrade using FTP
• Configurable Real Time Tracking & Logging
• Intelligent event control engine
• 1-Wire® protocol supported
• 3 Configurable GPIOs
• Roaming preference settings
• Harsh driving behavior events
• Configurable power management
• 32 user defined geofences
• Support Garmin® FMI
• Support external fuel level sensor

Location and tracking

ATrack AT1 is embedded with GPS. It does not support A-GPS, or GLONASS technology.

As the back-up, when no satellite signals are available, it uses Cell ID location (also known as LBS-tracking).

Mobile networks

ATrack AT1 has a Quad-band GSM 2G module that allows to operate it all over the world.

Power supply

External power supply might be 8-40V, which makes possible to use ATrack AT1 with all car models.

ATrack AT1 has a backup Li-Ion battery with a capacity of 650 mAh and voltage of 3.7V.

Local and remote management

ATrack AT1 can be fully controlled over GPRS. There is also a wide list of SMS commands in a human-friendly format, on which the device always replies back. It supports remote APN settings configuration by SMS.

LED Indication

ATrack AT1 model has three LEDs:

• Power LED – indicates power status
• GPS LED – indicates GPS signal
• GSM LED – indicates GSMS signal