GoSafe G3S is for business needs for sure. It designed for service providers, integrators and enterprise customers. As stated by the manufacturer, GoSafe G3S is not an expensive tracking device. Its characteristics are not quite rich but you have a necessary set for the vehicle tracking and telemetry data collection.
XiLi Technologies PT100
Server Integration
| Server Address | tracker.navixy.com | |
| Server IP Address | 217.23.132.215 | |
| Server port | 47713 |
General information
| Purpose | Pet | |
| Installation | Not required |
Housing
| Weight | 100 g (3.53 oz.) | |
| Size | 96x50x31.5 mm (3.78x1.97x1.24 in) |
GNSS Location
| Internal antenna (GNSS) | Yes | |
| GPS | Yes |
Connectivity
| Cellular network type | GSM Quad Band | |
| Internal antenna (Connection) | Yes | |
| Cellular network generation | 2G |
Tracking features
| Tracking modes | Continuous | |
| Location by Cell ID | Yes | Supported |
Events monitoring
| Battery low | Yes | Supported |
Self monitoring
| Network signal level | Yes | Supported |
| GNSS signal level | Yes | Supported |
| Internal battery level | Yes | Supported |
Remote management
| Server connection setup over SMS | Yes | Supported |
| Remote device configuration | Yes (over GPRS) | Supported |
| Forced GNSS location update over SMS | Yes | Supported |
Certification
| CE | Yes | |
| FCC | Yes | |
| EAC | Yes |
How to connect to Navixy server
Automatic activation (recommended)
The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.
You also need to keep the device with initial factory settings, in particular:
- Do not set any password, keep it clear (as by default)
- Do not set any master number prior to the device activation
- Do not set local Time zone, it must be UTC+0h (as by default)
Manual activation
In case automatic activation failed, you can try to register the device manually by sending following command to the device:
pw,123456,APN,{apn},{apn_user},{apn_pass},#
pw,123456,IP,tracker.navixy.com,47713#
The <APN> parameters depend on your GSM carrier.
More from XiLi Technologies
Activate a device on the platform Try it now
Haven’t found your device? We can add it Integrate
