Contact us Login LIVE DEMO FREE TRIAL

TotemTech AT07

Supported features

Server Integration
Server Addresstracker.navixy.com
Server IP Address217.23.132.215
Server port47701
General information
PurposeVehicle
InstallationProfessional
Housing
Weight100 g (3.53 oz.)
Size89x55x25 mm (3.5x2.17x0.98 in)
GNSS Location
External antenna (GNSS)Yes
GPSYes
Connectivity
Cellular network typeGSM Quad Band
Internal antenna (Connection)Yes
Cellular network generation2G
Interfaces
Number of outputs3
Number of inputs (all types)6
ACC/Ignition inputYes
Supported
Discrete inputsYes
Supported
Analog inputsYes
Supported
OutputsYes
Supported
Hardware features
Battery capacity800 mAh
Built-in batteryYes
Emergency buttonYes
Supported
Hardware extras
Emergency buttonYes
Supported
Driver ID readingYes
Supported
Tracking features
Tracking modesContinuous
OdometerYes
Supported
ECO drivingYes
Supported
Events monitoring
Battery lowYes
Supported
External power cut offYes
Supported
SIM card slot openYes
Supported
Self monitoring
Network signal levelYes
Supported
GNSS signal levelYes
Supported
External power source voltageYes
Supported
Internal battery levelYes
Supported
Remote management
Server connection setup over SMSYes
Supported
Remote device configurationYes (over GPRS)
Supported
Device ID typeStatic (IMEI)
Firmware update OTAYes
Forced GNSS location update over SMSYes
On request
Certification
CEYes
FCCYes

How to connect to Navixy server

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

Do not set any password, keep it clear (as by default)
Do not set any master number prior to the device activation
Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following commands to the device:

*000000,002,,,#
*000000,003,,47701,0#

The parameters depend on your GSM carrier.

Activate a device on the platform Try it now

Haven’t found your device? We can add it Integrate

Contacts

USA: +1 858 815 9045

Mexico: +52 334 1642158

UK: +44 808 1641499

Germany: +49 1573 5988250

Russia: +7 495 317 1622

Log in

Loading...

We use сookies to improve our website, products and related services, analyze site traffic, and serve targeted advertisements. If you continue to use our services, you consent to our use of сookies. Read more