Teltonika FM6320

Supported features

Server Integration

Server Address	tracker.navixy.com
Server IP Address	217.23.132.215
Server port	47776
Integrated on	24/11/2011
Revised on	29/01/2015

General information

Purpose	Vehicle
Installation	Professional

Housing

Weight	80 g (2.82 oz.)
Size	100x70x25 mm (3.94x2.76x0.98 in)
Waterproof class	IP4X

GNSS Location

External antenna (GNSS)	Yes
GPS	Yes
GLONASS	Yes

Connectivity

Cellular network type	GSM Quad Band
External antenna (Connection)	Yes
Cellular network generation	3G

Interfaces

1-Wire interface	Yes
RS232 interface	Yes	Supported
Number of RS232 interfaces	2
RS485 interface	Yes
Number of outputs	4
Number of inputs (all types)	7
ACC/Ignition input	Yes	Supported
Discrete inputs	Yes	Supported
Analog inputs	Yes	Supported
Impulse inputs	Yes	Supported
Outputs	Yes

Hardware features

Battery capacity	550 mAh
Built-in battery	Yes

Hardware extras

Fuel level sensor reading	Yes	Supported
Driver ID reading	Yes	Supported
External temperature sensor reading	Yes	Supported

Tracking features

Tracking modes	Continuous
Location by Cell ID	Yes	Supported
Smart power consumption	Yes	Supported
ECO driving	Yes	On request

Events monitoring

Battery low	Yes	On request
Input change	Yes	Supported
External power cut off	Yes	On request

Self monitoring

Network signal level	Yes	Supported
Network operator ID	Yes	Supported
GNSS signal level	Yes	Supported
External power source voltage	Yes	Supported
Internal battery level	Yes	Supported

CAN/OBDII reading

CAN/OBDII reader type

External

Supported

Remote management

Server connection setup over SMS	Yes	Supported
Remote device configuration	Yes (over GPRS)	Supported
Remote outputs control	Yes (over GPRS)	Supported
Firmware update OTA	Yes
Forced GNSS location update over SMS	Yes	On request

Certification

CE	Yes
FCC	Yes

How to connect to Navixy server

Teltonika FM6320 is tightly integrated with this software platform.

Automatic activation

The software platform supports automatic device activation by sending SMS commands, which includes all parameters in one command, applying APN settings, server address and port, as well as recommended tracking mode. These SMS commands can be sent in two formats:

Binary format (recommended) – one SMS to configure multiple parameters
Text ASCII format – one SMS to configure one parameter only

Binary format is recommended because it requires less messages to send from platform to device. When using binary format it is just 2-3 SMS to send, and in text format it’s more than 20 messages in total. However, depending on the SMS gateway and GSM operator binary SMS can not be delivered, and it requires to use Text messages.

Before the activation process please make sure that your device is switched ON and is located in the place with good GPS signal reception. You also need to keep the device with initial factory settings, in particular:

Do not set any password, keep them clear (as by default)
Do not set any master number prior to the device activation
Do not set local Time zone, it must be UTC+0h (as by default)

Manual configuration

If you experience issues with the SMS delivery from the platform to device in your country, you can setup device manually by using Teltonika Configurator software.