GPS tracker from Teltonika are valued for high quality of the hardware, stable firmware, also the ability to meet common use cases and apply custom specific configurations.

The range of models is quite wide and currently consists of devices for fleet management (FM series), asset tracking (AT series), as well as handheld trackers (GH series).

All devices are assembled in Vilnius, Lithuania. Established in 1998, the company has become one of the world's largest GPS tracker manufacturers.

Official website:

Looking for other Teltonika model? Suggest us to integrate it.

Server connection details

Supported features

Server Integration
Server IP Address217.23.132.215
Server port47776
Integrated on14/10/2013
General information
Size104.1x76.8x26.8 mm (4.1x3.02x1.06 in)
GNSS Location
Internal antenna (GNSS)
External antenna (GNSS)
Cellular network typeGSM Quad Band
Internal antenna (Connection)
External antenna (Connection)
Cellular network generation2G
1-Wire interface
RS232 interface
Number of RS232 interfaces2
Number of outputs4
Number of inputs (all types)8
Discrete inputs
Feature already supported
Analog inputs
Feature already supported
Hardware extras
Driver ID reading
Feature already supported
Tracking features
Tracking modesContinuous, Interval
Location by Cell ID
Feature already supported
Smart power consumption
Feature already supported
ECO driving
Feature already supported
Events monitoring
Battery low
Feature already supported
Input change
Feature already supported
External power cut off
Feature already supported
Self monitoring
Network signal level
Feature already supported
GNSS signal level
Feature already supported
GNSS satellites fixed
Feature already supported
External power source voltage
Feature already supported
Internal battery level
Feature already supported
CAN/OBDII reading
CAN/OBDII reader type
Feature already supported
CAN/OBDII parametersFuel level, fuel consumption, engine RPM, throttle position and other
Remote management
Server connection setup over SMS
Feature already supported
Remote device configurationYes (over SMS)
Remote outputs controlYes (over GPRS)
Feature already supported
Firmware update OTA

How to connect to Navixy server

Teltonika FM5300 is tightly integrated with this software platform.

Automatic activation

The software platform supports automatic device activation by sending SMS commands, which includes all parameters in one command, applying APN settings, server address and port, as well as recommended tracking mode. These SMS commands can be sent in two formats:

  • Binary format (recommended) – one SMS to configure multiple parameters
  • Text ASCII format – one SMS to configure one parameter only

Binary format is recommended because it requires less messages to send from  platform to device. When using binary format it is just 2-3 SMS to send, and in text format it’s more than 20 messages in total. However, depending on the SMS gateway and GSM operator binary SMS can not be delivered, and it requires to use Text messages.

Before the activation process please make sure that your device is switched ON and is located in the place with good GPS signal reception. You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep them clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual configuration

If you experience issues with the SMS delivery from the platform to device in your country, you can setup device manually by using Teltonika Configurator software.


USA: +1 858 815 9045

Mexico: +52 334 1642158

UK: +44 808 1641499

Germany: +49 1573 5988250

Russia: +7 495 223 0427

Log in