More from RedView

Click on the model image to see detailed information and current list of supported features

Looking for other RedView model? Suggest us to integrate it.

Server connection details

Supported features

Server Integration
Server Addresstracker.navixy.com
Server IP Address217.23.132.215
Server port46997
Housing
Weight670 g (23.63 oz.)
Size113x78x35 mm (4.45x3.07x1.38 in)
Interfaces
1-Wire interface
Feature can be supported upon request
RS232 interface
Feature can be supported upon request
Discrete inputs
Feature already supported
Analog inputs
Feature already supported
Frequency inputs
Feature can be supported upon request
Hardware features
Emergency button
Feature can be supported upon request
Hardware extras
Fuel level sensor reading
Feature already supported
Voice listening
Feature can be supported upon request
Driver ID reading
Feature can be supported upon request
External temperature sensor reading
Feature already supported
Camera
Feature can be supported upon request
Tracking features
Tracking modesContinuous
Odometer
Feature already supported
ECO driving
Feature already supported
Events monitoring
Battery low
Feature already supported
External power cut off
Feature already supported
Self monitoring
GNSS signal level
Feature already supported
CAN/OBDII reading
CAN/OBDII reader typeExternal, Yes
Feature can be supported upon request
Remote management
Server connection setup over SMS
Feature already supported
Remote device configurationYes (over GPRS)
Feature already supported

How to connect to Navixy server

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following commands to the device:

W000000,010,1234567890
W000000,011,{apn},{apn_user},{apn_pass}
W000000,012,{server_ip},46997
W000000,036,30

The <APN> parameters depend on your GSM carrier.

Contacts

USA: +1 858 815 9045

Mexico: +52 334 1642158

UK: +44 808 1641499

Germany: +49 1573 5988250

Russia: +7 495 223 0427

Log in

Login

[clean-login]

CLOSE
Register

[clean-login-register]

CLOSE
Loading...