Contact us Login LIVE DEMO FREE TRIAL

IMTSA TR2-OBD

Supported features

Server Integration
Server Addresstracker.navixy.com
Server IP Address217.23.132.215
Server port47702
General information
PurposeVehicle
InstallationNot required
Special form factorOBDII Dongle
Housing
Weight55 g (1.94 oz.)
Size65x61x26 mm (2.56x2.4x1.02 in)
GNSS Location
Internal antenna (GNSS)Yes
GPSYes
Connectivity
Cellular network typeGSM Quad Band
Internal antenna (Connection)Yes
Cellular network generation2G
Interfaces
Number of outputs1
ACC/Ignition inputYes
Supported
OutputsYes
Supported
Hardware features
Battery capacity180 mAh
Built-in batteryYes
Hardware extras
Driver ID readingYes
Supported
Tracking features
Tracking modesContinuous
Location by Cell IDYes
Supported
OdometerYes
Supported
ECO drivingYes
Supported
Events monitoring
Battery lowYes
Supported
External power cut offYes
Supported
Car crashYes
Supported
Self monitoring
Network signal levelYes
Supported
GNSS signal levelYes
Supported
External power source voltageYes
Supported
Internal battery levelYes
Supported
CAN/OBDII reading
CAN/OBDII parametersFuel level, fuel consumption, engine RPM, throttle position, speed, engine load, coolant temperature, DTC error codes and other
Check engine lightYes
Supported
DTC codes readingYes
Supported
Remote management
Remote device configurationYes (over GPRS)
Supported
Remote outputs controlYes (over GPRS)
Supported
Forced LBS location update over GPRSYes
On request
Forced GNSS location update over SMSYes
On request
Certification
CEYes
FCCYes

How to connect to Navixy server

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following command to the device:

APN;<apn>;<apnUser>;<apnPass>
GIP;217.23.132.215;47702;0

The <APN> parameters depend on your GSM carrier.

Activate a device on the platform Try it now

Haven’t found your device? We can add it Integrate

Contacts

USA: +1 858 815 9045

Mexico: +52 334 1642158

UK: +44 808 1641499

Germany: +49 1573 5988250

Russia: +7 495 223 0427

Log in

Loading...

We use сookies to improve our website, products and related services, analyze site traffic, and serve targeted advertisements. If you continue to use our services, you consent to our use of сookies. Read more