Carscop CCTR-830 is an OBDII-type tracker, that can be is easily installed into diagnostic port of a car. GPS tracker takes power from it but it can not read OBDII data.
Location and tracking
Carscop CCTR-830 is embedded with GPS and doesn’t have support of GLONASS and alternative systems. It either doesn’t support Assisted GPS (A-GPS) technology.
CCTR-830 can’t read any data from OBDII port. But it supports “Check engine” (MIL) and DTC error codes reading by SMS.
With Quad-band GSM/CDMA 2G module Carscop CCTR-830 can be operated all over the world.
Carscop CCTR-830 uses OBDII Connector Type B and voltage range 9-40V, which makes possible to install it both on cars and trucks.
CCTR-830 also features a built-in rechargeable backup battery. When fully charged it ensures about 1-2 hours of device operation (in normal conditions).
Local and remote management
Carscop CCTR-830 tracker can be fully controlled over GPRS. There is also a wide list of SMS commands in a human-friendly format, on which device always replies back. It supports remote APN settings configuration by SMS.
Carscop CCTR-830 has two LEDs
- Green LED indicates GSM/GPRS mode
- Red LED indicates GPS reception
|EU platform||tracker.navixy.com (184.108.40.206)|
|US platform||tracker.us.navixy.com (220.127.116.11)|
|Special form factor||OBDII Dongle|
|Weight||60 g (2.12 oz.)|
|Size||64.5x50x27 mm (2.54x1.97x1.06 in)|
|Internal antenna (GNSS)||Yes|
|Cellular network type||GSM Quad Band|
|Internal antenna (Connection)||Yes|
|Cellular network generation||2G|
|Battery capacity||250 mAh|
|Network signal level||Yes|
|GNSS signal level||Yes|
|Internal battery level||Yes|
|DTC codes reading||Yes|
|Server connection setup over SMS||Yes|
|Remote device configuration||Yes (over GPRS), Yes|
|Device ID type||Static (IMEI), Static|
|Message exchange format||ASCII|
|Forced GNSS location update over SMS||Yes|