CalAmp LMU-3030

Supported features

Server Integration

Server Address	tracker.navixy.com
Server IP Address	217.23.132.215
Server port	47710

General information

Purpose	Vehicle
Installation	DIY
Special form factor	OBDII Dongle

Housing

Weight	52 g (1.83 oz.)
Size	43x64x25 mm (1.69x2.52x0.98 in)

GNSS Location

Internal antenna (GNSS)	Yes
GPS	Yes
Assisted GPS	Yes

Connectivity

Cellular network type	HPSA/UMTS 850/900/1900/2100
Internal antenna (Connection)	Yes
Cellular network generation	2G, 3G

Interfaces

Number of inputs (all types)	1
ACC/Ignition input	Yes	Supported
Discrete inputs	Yes	Supported

Hardware extras

Voice listening

Yes

On request

Tracking features

Tracking modes	Continuous
Location by Cell ID	Yes	Supported

Self monitoring

Network signal level	Yes	Supported
Network operator ID	Yes	Supported
GNSS signal level	Yes	Supported
External power source voltage	Yes	Supported

CAN/OBDII reading

CAN/OBDII reader type	External	Supported
CAN/OBDII parameters	Speed, fuel level, fuel consumption, engine RPM, throttle position, mileage, inst. fuel consumption, engine hours

Remote management

Server connection setup over SMS	Yes	Supported
Remote device configuration	Yes (over GPRS)	Supported
Forced GNSS location update over SMS	Yes	Supported

How to connect to Navixy server

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

Do not set any password, keep it clear (as by default)
Do not set any master number prior to the device activation
Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following commands to the device:

!RP,2306,0,<apn>
!RP,2314,0,<apnUser>
!RP,2315,0,<apnPass>
!RP,1024,35,255,1
!RP,769,0,47710
!RP,2319,0,<server_ip>
!RP,768,0,<server_ip>
!RP,1024,25,255,2
!R3,70,0
!R3,1,123