Contact us Login LIVE DEMO FREE TRIAL

Bitrek BI 520 TREK

Supported features

Server Integration
Server Addresstracker.navixy.com
Server IP Address217.23.132.215
Server port47776
General information
PurposeVehicle
InstallationProfessional
Housing
Weight65 g (2.29 oz.)
Size96x60x14 mm (3.78x2.36x0.55 in)
GNSS Location
Internal antenna (GNSS)Yes
GPSYes
GLONASSYes
Connectivity
Cellular network typeGSM 900/1800
Internal antenna (Connection)Yes
Cellular network generation2G
Interfaces
1-Wire interfaceYes
Number of outputs2
Number of inputs (all types)5
ACC/Ignition inputYes
On request
Discrete inputsYes
Supported
Analog inputsYes
Supported
Impulse inputsYes
On request
Frequency inputsYes
Supported
Hardware features
Internal temperature sensorYes
Supported
Hardware extras
Fuel level sensor readingYes
Supported
Driver ID readingYes
Supported
External temperature sensor readingYes
Tracking features
Tracking modesInterval
OdometerYes
Supported
Self monitoring
Network operator IDYes
Supported
Network roaming statusYes
Supported
GNSS signal levelYes
Supported
External power source voltageYes
Supported
Internal battery levelYes
Supported
CAN/OBDII reading
CAN/OBDII reader typeExternal
Supported
Remote management
Server connection setup over SMSYes
Supported
Remote device configurationYes (over SMS)
Supported
Remote outputs controlYes (over SMS)
Supported

How to connect to Navixy server

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following commands to the device:

setparam 0245 {server_hostname};
setparam 0246 47776;
setparam 0242 {apn};
setparam 0243 {apn_user};
setparam 0244 {apn_pass};
setparam 0903 100;
setparam 0011 100;
setparam 0012 300;
setparam 0013 10;
setparam 0470 1;
setparam 0474 3;
setparam 0420 1;
setparam 0410 1;
setparam 0450 1;
setparam 0440 1;

The <APN> parameters depend on your GSM carrier.

Activate a device on the platform Try it now

Haven’t found your device? We can add it Integrate

Contacts

USA: +1 858 815 9045

Mexico: +52 334 1642158

UK: +44 808 1641499

Germany: +49 1573 5988250

Russia: +7 495 317 1622

Log in

Loading...

We use сookies to improve our website, products and related services, analyze site traffic, and serve targeted advertisements. If you continue to use our services, you consent to our use of сookies. Read more