Bitrek BI 920 TREK
Bitrek BI 920 TREK OBDII is a universal vehicle location device that work with GPS, GLONASS, Galileo and Beidou networks. It can be used for a fleet management or personal purpose.
The package contents:
- GPS Tracker
- Power (and additional sensors) cable
This tracker has a solid waterproof housing. It has internal GNSS antenna and external GSM antenna. This tracker can be easily connected with OBDII port (via FMS protocol) for reading data from on-board PC. It supports driver ID reading and voice communication options.
Location and tracking
Bitrek BI 920 TREK is a universal vehicle location device that work with GPS, GLONASS, Galileo and Beidou networks.
The device supports only continuous tracking mode.
With Quad-band GSM 2G module Bitrek 910 can be operated all over the world.
Local and remote management
Bitrek BI 920 tracker can be fully controlled over GPRS. There is also a wide list of SMS commands in a human-friendly format, on which device always replies back. It supports remote APN settings configuration by SMS.
Also it is fully configurable via serial cable using proprietary software (Bitrek Configurator)
Bitrek BI 920 TREK takes power supply from OBD-port, so you can install it on any car, that has an OBD-port.
It has a built-in battery that can support the 8 hours of autonomous work.
Bitrek BI 920 TREK has 3 LEDs
- Red for Power
- Green for GNSS
- Yellow for GSM
|EU platform||tracker.navixy.com (188.8.131.52)|
|US platform||tracker.us.navixy.com (184.108.40.206)|
|Weight||200 g (7.05 oz.)|
|Size||125x95x29 mm (4.92x3.74x1.14 in)|
|Internal antenna (GNSS)||Yes, No|
|External antenna (GNSS)||Yes, No|
|Cellular network type||GSM 900/1800|
|Internal antenna (Connection)||Yes|
|External antenna (Connection)||Yes|
|Cellular network generation||2G|
|Number of outputs||2|
|Number of inputs (all types)||8|
|Battery capacity||1000 mAh|
|Fuel level sensor reading||Yes|
|Driver ID reading||Yes|
|Location by Cell ID||Yes|
|Network signal level||Yes|
|GNSS signal level||Yes|
|GNSS satellites fixed||Yes|
|CAN/OBDII reader type||Yes, Internal|
|Server connection setup over SMS||Yes|
|Remote device configuration||Yes (over SMS), Yes|
|Remote outputs control||Yes (over SMS), Yes|