Contact us Login LIVE DEMO FREE TRIAL

Arnavi Integral-2

Supported features

Server Integration
Server Addresstracker.navixy.com
Server IP Address217.23.132.215
Server port47756
General information
PurposeVehicle
InstallationProfessional
Housing
Weight60 g (2.12 oz.)
Size70x53x22 mm (2.76x2.09x0.87 in)
GNSS Location
Internal antenna (GNSS)Yes
GPSYes
GLONASSYes
Connectivity
Cellular network typeGSM Quad Band
Internal antenna (Connection)Yes
Cellular network generation2G
Interfaces
1-Wire interfaceYes
RS485 interfaceYes
Number of outputs2
Number of inputs (all types)3
Discrete inputsYes
Supported
Analog inputsYes
Supported
Impulse inputsYes
Supported
Frequency inputsYes
Supported
Hardware extras
Fuel level sensor readingYes
Supported
Driver ID readingYes
Supported
External temperature sensor readingYes
Tracking features
Tracking modesContinuous, Interval
Location by Cell IDYes
Supported
OdometerYes
Supported
Events monitoring
External power cut offYes
Supported
Self monitoring
Network signal levelYes
Supported
GNSS signal levelYes
Supported
External power source voltageYes
Supported
Internal battery levelYes
Supported
CAN/OBDII reading
CAN/OBDII reader typeExternal
Supported
Remote management
Server connection setup over SMSYes
Supported
Remote device configurationYes (over GPRS)
Supported
Remote outputs controlYes (over GPRS)
Forced GNSS location update over SMSYes
On request

How to connect to Navixy server

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following commands to the device:

123456*SETP*#2={apn},{apn_user},{apn_pass}
123456*SETP*#1={server_hostname},47756
123456*SETP*#5=100,15,50,120

The <APN> parameters depend on your GSM carrier.

Activate a device on the platform Try it now

Haven’t found your device? We can add it Integrate

Contacts

USA: +1 858 815 9045

Mexico: +52 334 1642158

UK: +44 808 1641499

Germany: +49 1573 5988250

Russia: +7 495 317 1622

Log in

Loading...

We use сookies to improve our website, products and related services, analyze site traffic, and serve targeted advertisements. If you continue to use our services, you consent to our use of сookies. Read more