Contact us Login LIVE DEMO FREE TRIAL

Albatross S8.5

Supported features

Server Integration
Server Addresstracker.navixy.com
Server IP Address217.23.132.215
Server port47699
General information
PurposeVehicle
InstallationProfessional
Housing
Weight110 g (3.88 oz.)
Size89x55x25 mm (3.5x2.17x0.98 in)
GNSS Location
Internal antenna (GNSS)Yes
External antenna (GNSS)Yes
GPSYes
Connectivity
Cellular network typeGSM Quad Band
Internal antenna (Connection)Yes
External antenna (Connection)Yes
Cellular network generation2G
Interfaces
1-Wire interfaceYes
Supported
RS232 interfaceYes
Supported
RS485 interfaceYes
Number of outputs2
Number of inputs (all types)5
ACC/Ignition inputYes
Supported
Discrete inputsYes
Supported
Analog inputsYes
Supported
Impulse inputsYes
On request
OutputsYes
Supported
Hardware features
Battery capacity550 mAh
Built-in batteryOptional
Hardware extras
Emergency buttonYes
Supported
Driver ID readingYes
Supported
External temperature sensor readingYes
Supported
Tracking features
Tracking modesContinuous, Interval
OdometerYes
On request
ECO drivingYes
Supported
Events monitoring
External power cut offYes
Supported
Car crashYes
Supported
Self monitoring
Network signal levelYes
On request
Network operator IDYes
On request
GNSS signal levelYes
Supported
External power source voltageYes
Supported
Internal battery levelYes
Supported
CAN/OBDII reading
CAN/OBDII reader typeExternal
Supported
CAN/OBDII parametersSpeed, fuel level, fuel consumption, engine RPM, throttle position, mileage, inst. fuel consumption, engine hours
Remote management
Server connection setup over SMSYes
Supported
Remote device configurationYes (over GPRS)
Supported
Remote outputs controlYes (over GPRS)
Supported
Firmware update OTAYes
Certification
CEYes
FCCYes

How to connect to Navixy server

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following command to the device:

$AL+COMM=0000,3,{sms_gateway},,{apn},{apn_user},{apn_pass},1,217.23.132.215,47699,300,rn

$AL+UNPM=0000,{device_id_generated_by_api_server},0000,9998,7,7,7,7,4,10rn

The <APN> parameters depend on your GSM carrier.

More from Albatross

Activate a device on the platform Try it now

Haven’t found your device? We can add it Integrate

Contacts

USA: +1 858 815 9045

Mexico: +52 334 1642158

UK: +44 808 1641499

Germany: +49 1573 5988250

Russia: +7 495 223 0427

Log in

Loading...

We use сookies to improve our website, products and related services, analyze site traffic, and serve targeted advertisements. If you continue to use our services, you consent to our use of сookies. Read more